Coil-less FM Transmitter

Electronic Schematics > RF circuit > Coil-less FM Transmitter

---

The RF oscillator using the inverter N2 and 10.7Mhz ceramic filter is driving the parallel combination of N4 to N6 through N3.Since these inverters are in parallel the output impedance will be low so that it can directly drive an aerial of 1/4th wavelength. Since the output of N4-N6 is square wave there will be a lot of harmonics in it. The 9th harmonics of 10.7Mhz (96.3Mhz) will hence be at the center of the FM band. N1 is working as an audio amplifier. The audio signals from the microphone are amplified and fed to the varycap diode. The signal varies the capacitance of the varycap and hence varies the oscillator frequency which produce Frequency Modulation.

Title: Coil-less FM Transmitter
electronic circuit
Source: unknown
Published on: 2005-08-27
Reads: 2896
Print version:

Other electronic circuits and schematics from RF circuit

---

• Video to RF Modulator

• A small FM transmitter (SMD)

• Medium range transmitter

• Economy short-wave receiver

• Powerful AM transmitter

• FM Transmitter with Opamp

• Bipolar Regenerative receiver

• 20dB VHF Amplifier

• 6 x 6 Loop Antenna

• SW RF Pre-Amplifier