Site: ElShem.com

Headphone Amplifier

High Quality unit

No need for a preamplifier

Amplifier parts:

P1_____________22K Log.Potentiometer (Dual-gang for stereo)

R1____________560R 1/4W Resistor
R2,R3__________10K 1/4W Resistors
R4_____________12K 1/4W Resistor
R5,R6___________2R2 1/4W Resistor
R7_____________22R 1/2W Resistor

C1______________1µF 63V Polyester Capacitor
C2,C3,C4______100µF 25V Electrolytic Capacitors
C5_____________22pF 63V Polystyrene or Ceramic Capacitor
C6_____________22µF 25V Electrolytic Capacitor

IC1___________LM833 or NE5532 Low noise Dual Op-amp

Q1,Q3_________BC337 45V 800mA NPN Transistors
Q2,Q4_________BC327 45V 800mA PNP Transistors

J1______________RCA audio input socket

Power supply parts:

R7______________2K2 1/4W Resistor

C7,C8________2200µF 25V Electrolytic Capacitors

D1____________100V 1A Diode bridge
D2____________5mm. or 3mm. Red LED

IC2___________7815 15V 1A Positive voltage regulator IC
IC3___________7915 15V 1A Negative voltage regulator IC

T1____________220V Primary, 15 + 15V Secondary 5VA Mains transformer

PL1___________Male Mains plug

SW1___________SPST Mains switch

Notes:

• Can be directly connected to CD players, tuners and tape recorders.
• Tested with several headphone models of different impedance: 32, 100, 245, 300, 600 & 2000 Ohms.
• Can drive old 8 Ohms impedance headphones, but these obsolete devices are not recommended.
• Schematic shows left channel and power supply.
• Numbers in parentheses show IC1 right channel pin connections.
• A correct grounding is very important to eliminate hum and ground loops. Connect in the same point the ground sides of J1, P1, C2, C3 & C4. Then connect separately the input and output grounds at the power supply ground.

Technical data:

Output voltage: Well above 5V RMS on all loads

Sensitivity: 250mV input for 5V RMS output

Frequency response: Flat from 30Hz to 20KHz

Total harmonic distortion @ 1KHz & 10KHz: Below 0.005% on 32 Ohms load and up to 4V RMS output (typical 0.003%)
Total harmonic distortion @ 1KHz & 10KHz: Below 0.005% on 100 to 2000 Ohms load and up to 5V RMS output (typical 0.003%)

Unconditionally stable on capacitive loads

Page URL: http://www.elshem.com/pageid--28.html

Site URL: http://www.elshem.com

© ElShem.com