Intermittent wiper controller
Figure1. Intermittent wiper controller.
The intermittent wiper circuit shown above causes the auto's windshield wipers to wipe once every several seconds instead of constantly wiping. The circuit may be added to older cars to provide the intermittent function or it may be used to replace broken wiper circuits in modern cars. The delay is continuously adjustable with the potentiometer but switch selected fixed resistors may also be used, if desired. The circuit should be connected to +12 volts at the same point as the original wiper power switch so that the proper fuse protection is preserved. The 12 volt relay should have contacts rated for a few amps since the wiper motor will draw a considerable start current but most automotive relays are adequate. The circuit should be quite trouble-free and will work on the first try if no wiring errors are made!
Title: Intermittent wiper controller
electronic circuit
Source: http://www.wenzel.com
Published on: 2005-08-15
Reads: 2041
Print version:
Other electronic circuits and schematics from Automotive
-
Synchronized multi-spark module (SMSM) for Electronic Ignition Devices (EID)
-
Dome light dimmer for Cars
-
Charge Monitor for 12V lead acid battery
-
Car Alarm Arming Horn Beep Canceller
-
Wiper Speed Control
-
Headlights Timer
-
Automatic Headlight Brightness Switch
-
Headlight Flasher
-
Pulsing Third Brake Light
-
Ultrasonic Parking Sonar