Band 2 Preamplifier
This is a VHF amplifier for the Band 2 Radio Spectrum tuning approximately 88 - 108 Mhz.
Band 2 Preamplifier diagram
The circuit uses two 2N3819 FET's in cascode configuration. The lower FET operates in common source mode, while the upper FET, operates in common gate, realising full high frequency gain. The bottom FET is tunable allowing a peak for a particular station. Coil details follow:
L1 4 turns of 18swg air spaced with a 1cm diameter, the tap is one turn up from earth end...
L2 4 turns of 18swg air spaced with 1 cm diameter. The coupling coil is 1 turn interwound from the supply end. Enamel coated wire must be used.
Title: Band 2 Preamplifier
electronic circuit
Source: unknown
Published on: 2012-09-20
Reads: 585
Print version:
Other electronic circuits and schematics from Audio
-
Portable Mixer
-
Electronics Attenuator
-
250 mW Audio Amplifier
-
Portable Headphone Amplifier
-
Stereo Preamplifier with Bass-boost
-
Headphone Amplifier
-
Loudspeaker Test Box
-
60W Guitar Amplifier
-
22 Watt Audio Amplifier
-
Audio Pre-Amplifier