DC to DC Converter
The circuit below is a DC to DC converter using a standard 12 VAC center tapped power transformer wired as a blocking oscillator. The circuit is not very efficient but will produce a high voltage usable for low power applications. The input battery voltage is raised by a factor of 10 across the transformer and further raised by a voltage tripler consisting of three capacitors and diodes connected to the high voltage side of the transformer. The circuit draws about 40 milliamps and should operate for about 200 hours on a couple of 'D' alkaline batteries. Higher voltages can be obtained by reducing the 4.7K bias resistor.
DC to DC Converter circuit
Title: DC to DC Converter
electronic circuit
Source: unknown
Published on: 2007-07-21
Reads: 2079
Print version:
Other electronic circuits and schematics from Power
-
3-30 V/2.5 A Stabilized power supply
-
High Voltage, Low Current Supply
-
Nicad Battery Charger
-
Ultra low drop linear voltage regulator
-
Voltage Inverter II
-
Dual Regulated Power Supply
-
12 Volt 30 Amp PSU
-
LASER Power Supply
-
Over / Under Voltage Cut-Out
-
Self-powered Fast Battery-Tester